Error8 Videos

Z-Axis wobble on the Da Vinci Pro 3D printer

If your Da Vinci Pro printer is also bothered by a wobbling Z axis, you can print this section to prevent the shaft from wobbling. This is a very simple solution that angry tongues claim is actually not good at all, but I can assure you it has helped me a lot.

PTFE tube for the Da Vinci Pro filament holder I made

After about 1 year of intensive use, I discovered that the filament holder I made and shared on Thingiverse contains a small mistake. But, luckily not much is going on, you can easily solve this problem. Look.

Unclogging the nozzle of the Da Vinci Pro machine. AGAIN!

Again a video about removing a blockage from the Da Vinci Pro printer, but this time I show it in a different way so that it might be even clearer what to do to clear the blockage.

Unclogging the nozzle of the Da Vinci Pro 1.0 3D printer

Nothing is more annoying than a blockage in the nozzle of your 3D printer, or wait … A blockage in the nozzle of your XYZPrinting Da Vinci Pro printer is even worse. In this video I show how I can easily solve the blockage

Repairing the pneumatic push fitting of the Da Vinci Pro 1.0 and 3-in-1

One of the common failures in the XYZPrinting Da Vinci Pro printer is the breakdown of the pneumatic push fitting used on the printer’s extruder. This push fitting has, as standard, too few teeth to hold the PTFE tube and must therefore be replaced by another model that has enough teeth. In this video I […]