Printing ABS filament in an open printer

Presenter

A lot of people have the same question, is it possible to print ABS with a printer that doesn’t have an enclosure around the heated bed? Well, the short answer is no, but if the print is very small, then it is possible, even without a heated bed. Using Filabond, an adhesive material that you can put on the bed to make parts stick a little better, gives you just enough adhesion to print ABS without the problem of disconnecting from the bed. See the video to watch the result.

(Visited 6 times, 1 visits today)

You might be interested in

LEAVE YOUR COMMENT

Your email address will not be published. Required fields are marked *