Simplify3D users can solve a problem I had in a previous video


Oops, if you make videos, then sometimes it goes wrong, like this morning when I released THIS video about designing for 3D printing. In that video I pick up a point that is not wrong in itself because you really have to take into account the way you manufacture something, but I use Simplify3D as a slicer and that software is capable correcting my mistakes without any problem.

YouTube follower unisoldhd told me that I had to make two small changes in my slicer settings and that Simplify3D would just make my print, and that was completely correct. See for yourself what happens.

Thank you unisoldhd for this correction. Super that you have taken the trouble to respond, this makes the world a lot nicer.

With best regards,
Brian 3D-PrintCreator

(Visited 54 times, 1 visits today)

You might be interested in


Your email address will not be published. Required fields are marked *